Add-On For Mass Storage System - 42"

Mass Gym Storage Specifications:

• Provides up to 42" of usable storage space per each shelf (dumbbell, kettlebell, bumper plate, and med/slam ball)
• Single Upright is constructed of 3" x 3" - 11 gauge steel
• Does not need to be bolted to the floor but can be bolted to the floor if desired
• Mass Storage Dimensions:
  
  • Length: 48.5"
  • Width: 28"
  • Length: 48.5"
  • Height: 69.5"
  • Measurements are approximations and may vary slightly
• Bumper Plate Rack: Equipped with divider supports that prevent sagging when loaded as well as keeping plates from dropping through the rack rails if improperly placed on the rack.
  • 35.5" of storage space for bumper plates
• Dumbbell Rack: Made from 7 gauge steel and lined with rubber. The dumbbell rack has a slight angle to allow easy placement of the dumbbells. The dumbbell rack can hold any dumbbell from 5lb and heavier that has a handle no more than 6.5" in length. Three Dumbbell Racks provide enough storage space for a Vulcan Elite Hex/Round or Vulcan Pro Hex 5 lb. to 50 lb. set and still allow for two racks (kettlebell racks and or Med-ball racks) within the V-MSS
• Med Ball/Slam Ball Rack: Made from 2.5 mm thickness steel tubing. The Med Ball storage is made for the storage of slam balls and medicine balls only.
• Add-On storage can also be used as an add on to compatible Vulcan Power rack or Elite Rig
  • Please Note: the selection of certain combinations of shelving may not allow space for a 5th shelving unit.
• Barbell Storage: Attaches at the bottom of the unit on either side of the storage rack at approximately 6" above the floor.
• Weight Plate Storage: approximately 8.5" of storage
• Band Storage: approximately 8" of storage space
• Storage for CrossFit Gyms, High School & College Gyms, & Garage Gym
• Additional equipment shown or additional storage sections are not included. Equipment and V-MSS-42 are shown for illustrative purposes.
• This item ships via Freight
• Made in USA: No

---